RADIAL HONEY EXTRACTOR МР-48н for 48 frames, 220 V, stainless steel

Honey extractor of middle-sized, designed for honey pumping in apiaries of up to 150 beehives. A radial arrangement of frames is used for pumping. The maximum number of frames to be pumped per cycle depends on the frame size:

• 145 mm - 48 pcs,
• 230 mm (Ruth) - 48 pcs,
• 300 mm (Dadan) - 24 pcs.

Honey extractor МР-48н, 220 V is made from the following materials: 

1. Tank:

• Material: AISI 304 food-grade stainless steel.
• Wall thickness, mm: 0.8,
• Bottom thickness, mm: 0,8,
• Tapered bottom,
• Welded tap.

2. Drum (rotor):

• Drum type: radial,
• Material: AISI 304 food grade stainless steel,
• Shaft: AISI 304 round bar.

3. Frame (legs and cross member assembly):

• Material: steel 3,
• Thickness of the material, mm: at least 2.5 mm.

The honey extractor is driven by a gear motor with continuously variable speed regulation.

There is also a control panel “BeeStar” with 9 recorded automatic programs that can be edited (any of 9 programs can be edited, the setting instruction and the characteristics of the standard programs are described in the general data sheet on the honey extractor). The standard controller has 6 programs for the radial type and 3 for the cassette type. The programs differ in speed and pumping time.

Pumping time on the honey extractor МР-48н, 220V:

Frame 145 mm - 13-18 minutes,

Frame 230 mm (Ruth) - 23-28 minutes,

Frame 300 mm (Dadan) - 33 minutes.

For protection during the operation, the control panel is equipped with an emergency stop button, the tank with frames is covered with special protective polycarbonate glass (also serves as protection against contamination), which is attached to the hinges.

Warranty for the honey extractor МР-48н, 220 V is 24 months.

Completion kit of МР-48н, 220 V:

• Honey extractor МР-48н, 220 V,
• The warranty card (24 months),

Instructions for setting/adjusting the remote control and using the honey extractor.